HID Cornering Lamp Bulb

Headlamps

HID Cornering Lamp Bulb

• Left Cornering Lamp (L148) and Right Cornering Lamp (L149) can be checked using Headlamp Range/Cornering Lamp Control Module (J745) Output Diagnostic Test Mode (DTM) => [ Headlamp Range/Cornering Lamp Control Module Output Diagnostic Test Mode ] HID Headlamps.

• Replacing the cornering lamp bulb in a right headlamp is shown in the following illustrations.

• Replacing a left cornering lamp bulb and a right cornering lamp bulb is identical.

Removing:

- Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).

• During removal and installation, leave ignition key with remote control inside the vehicle to prevent the doors from locking and possibly activating the Coming Home / Leaving Home functions on its own.

- Press wire brackets - 1 - and - 2 - to the side in - direction of arrow -.





- Remove cover cap - 3 - from headlamp.

• The cornering light bulb - 1 - is clipped into the reflector - 2 -.





• When removing cornering light bulb, connector - 3 - is not disconnected.

- Press connector and the bulb socket in - direction of arrow - until bulb comes loose.

- Pull cornering lamp out of reflector by grasping on the harness connector - 3 -.

- Guide the cornering lamp bulb out of the headlamp housing with the connector still connected.

- Remove the cornering lamp bulb - 2 - from the connector - 1 -.





Installing:

Install in reverse order of removal, noting the following:

- Guide cornering lamp into headlamp housing.

- Push cornering lamp - 1 - into reflector to its installation position as depicted in the illustration.





• Cornering light bulb must engage audibly.

• When installing cover cap, check gasket for proper fitting. It is destroyed by entry of water into headlamp.

• Do not touch the glass of the light bulb, when installing. Your fingers will leave traces of grease on the glass which, when the light is switched on, will evaporate and cloud the glass.

- Connect the cornering light bulb connector.

- Check headlamp for function.

- Check headlamp adjustment and adjust headlamp if necessary.