Steering Column Electronic Systems Control Module (J527), Kostal, From 11.09

Steering Column Switch

Steering Column Electronic Systems Control Module (J527), Kostal, From 11.09

Removing:

CAUTION!
• Risk of airbag deployment!

• The airbag could deploy if the airbag unit is handled incorrectly.

• Observe safety precautions when working on the airbag.

CAUTION!
The removal and installation of individual steering column switch components must be done in the specified sequence, refer to => [ Steering Column Switch Components, Removal and Installation Sequence, From 11.09 ]. Steering Column Switch Components, Removal and Installation Sequence, From 11.09

- Disconnect batter. Refer toy => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

Remove the following components in order:

- Remove steering wheel.

- Remove steering column trim.





- Disconnect the connectors - 1 -, - 2 -, - 3 -, - 4 - and - 5 -, depending on the vehicle equipment level.

- Remove bolt - arrow B -.

• Do not turn the spiral spring on the steering column electronic systems control module for the steering column electronics from its center position during removal. The front wheels must be in the straight-ahead position.

- Unlock both catches - arrows A - and remove the steering column electronics control module from the steering column switch.

Installing:

CAUTION!
The turn signal switch lever could break when installing the control module.

The turn signal lever must be in the 0 position when installing the spiral spring so that it does not fall out.

Install in reverse order of removal, noting the following:

- Mount the steering column electronic systems control module on the steering column switch making sure it is straight until it latches.

- Install the bolt for the steering column electronic systems control module on the steering column switch module and tighten it to 1.5 Nm.

- Install all components in reverse order of removal.