Striker Pin With Closing Aid Motor, Adjusting

Rear Lid

Striker Pin with Closing Aid Motor, Adjusting

• Latch bracket - 1 - can be slid in oversized holes by loosening bolts - 2 -.

• Adjust striker pin with closing aid - 1 - so that recess of rear lid lock with detent engages at center on latch bracket - 1 -.

- Remove the lock carrier cover.





- Open rear lid and bring lock into "closed" position.

Striker pin moves into "closed" position.

- Disconnect connector - 3 - from closing aid motor.

- Loosen stop buffer. Refer to => [ Stop Buffer, Adjusting ] Stop Buffer, Adjusting

- Disengage the latch bracket - 1 -.

- Bring the striker pin - 1 - into the top position and tighten the bolts - 4 -.

- Close rear lid and check adjustment.

- Screw - 4 - tightening specification: 23 Nm.