Rear Lid Motor Control Module

Rear Lid

Rear Lid Motor Control Module





- Remove the headliner.

- Disconnect connector - 8 - at motor in rear lid control module - 1 -.

- Loosen hex nut - 2 -, do not turn under.

- Rotate screw - 7 - in picture and move motor - 1 - out of installation position to center of vehicle.

Bracket - 4 - is not removed.

Installation





- Slide motor - 1 - into installation position under hex nut - 2 - and splines - arrow - in bracket - 4 -.

- Set screw - 7 - on but do not tighten.

- Align motor horizontally and free of tension.

- Tighten the screw - 7 -, tightening specification: 22 Nm.

- Tighten the nut - 2 -, tightening specification: 22 Nm.

- Secure connector - 8 - to motor - 1 -.

Installation of motor in rear lid control module

- Allow rear to completely open and close once via electric operation. This makes motor in rear lid control module ready for operation and activates the pinch protection.

Installing a new motor in rear lid control module

• Motor in rear lid control module is delivered in "closed" condition.

- Close the rear lid manually and then open it again but only half way up.

- At the same time press the inner and outer buttons.

- Release both buttons.

CAUTION!
The rear lid should now move without pinch protection.

• The rear lid goes all the way up and the motor in the control module is now adapted.

- Then perform a function test of electric operation.