Power Sliding Door Drive

Power Sliding Door Drive

Description






All vehicles equipped with power sliding doors will have two power sliding door drive assemblies. One drive for the left sliding door and one for the right. The drive assemblies are mounted in the vehicle body cavity where the manual lower sliding door track would normally be located. The drive assemblies are attached to the sliding door lower hinge via a drive bracket. This bracket is attached to a cable that moves fore and aft to open and close the power sliding doors.

The power sliding door drive assembly consists of the following parts:

• The sliding door track (5).

• The power sliding door drive cable, drive tensioner and pulleys (4).

• The power sliding door motor (3).

• The power sliding Door control module (2).

• The power sliding door drive assembly wire harnesses (1).

The following are the serviceable components of the power sliding door drive:

• The PSDM.

• The PSDM to drive motor wire harness.

• The lower door track, cable and motor.

The power sliding door drive motor is not serviced as a separate component. If the motor is inoperative or damaged the complete power sliding door drive must be replaced, whenever a new power sliding door drive service part is installed and the PSDM is functioning properly, the original PSDM must be transferred to the new drive. Refer to => [ Power Sliding Door Drive ] Power Sliding Door Drive.