Remote Start Inoperative

Remote Start Inoperative

For a complete wiring diagram, refer to






Test Step 1 - Remote Start Parameters Not Met/Faulty Component

Refer to the Data Display in the scan tool to view possible causes of the inoperative remote start system.

• Possible causes for the inoperative remote start system:

• Abort.

• Battery voltage high.

• Battery voltage low.

• Brake pressed.

• Coolant temperature high.

• Crank no start.

• Driver door ajar.

• Failed counter reached (start).

• Hazard lamps switch pressed.

• Hood ajar.

• Ignition in run/start.

• Ignition not in lock.

• Ignition signal not available from other module.

• Invalid key.

• Key in ignition.

• Left rear door ajar.

• Low RPM shutdown.

• MIL on.

• No automatic transmission.

• No hood switch (inoperative).

• Normal time out customer access.

• Normal time out run mode (15 minutes).

• Not configured.

• Not enabled.

• Not in park or neutral.

• Not programmed.

• Oil pressure low.

• Panic mode activated.

• Passenger door ajar.

• Power loss.

• Right rear door ajar.

• RKE off message.

• RPM too high (exceeds 2500).

• Start counter reached.

• Trunk/liftgate ajar.

• Vehicle speed high.

• VTA alarming.

If all of the above items are OK and the remote starting system will not operate, refer to => [ Remote Start Inoperative - Antenna ] Remote Start Inoperative - Antenna.