Seat Back Cover and Cushion

Seat Back Cover and Cushion

Special tools, testers and auxiliary items required

• Trim Removal Wedge (RMCP101)

• On all leather trimmed seats, back cover can be removed from the back foam pad. On cloth trimmed seats, the back cover does not separate from the foam pad.

Removing

- Remove the seat back. Refer to => [ Seat Back ] Seat Back.

- Remove the headrest sleeve. Refer to => [ Headrest Sleeve ] Headrest Sleeve.

- Using trim removal wedge (RMCP101) , remove the pull strap bezel.

- Unzip the trim cover sides.

- Open up the trim cover lower closeout.

- Roll over the cover and cushion and pull to the top of the frame.

Installing

- Locate stow strap underneath cushion/cover and pull the end of the strap through the slit of the cover.

- Invert cover and install cushion on to the back frame.

- Close up the cover lower closeout.

- Slide the stow and go strap through the bezel. Push bezel onto the back frame slot underneath the cover.

- Install the headrest sleeve. Refer to => [ Headrest Sleeve ] Headrest Sleeve.

- Install the seat back. Refer to => [ Seat Back ] Seat Back.