Seat Leg Latch Actuator Position Switch

Seat Leg Latch Actuator Position Switch

Removing






• The procedure for replacing the seat leg latch position switch is the same for both the 60 and 40 third row power folding seats. The following steps should be performed only on the seat with the inoperative seat leg latch position switch.

- Remove the effected third row power folding seat. Refer to => [ Seat ] Seat.

- Remove the seat cushion and cover assembly. Refer to => [ Seat Cushion and Cover ] Seat Cushion and Cover.

- Disconnect the electrical connector for the effected switch (1).






- Using the appropriate size drill bit, remove the rivet (2) securing the switch (1) to the seat leg (3).

- Remove the tie strap holding the switch wire harness and leg latch release cable (5) to the seat leg.

- Remove the switch from the seat leg.

Installing






- Position the switch (1) onto the seat leg (3). Ensure the alignment stud is in the hole on the leg and that the rivet hole is aligned.

- Install a new rivet (2).

- Install the tie strap holding the switch wire harness and leg latch release cable (5) to the seat leg.






- Connect the switch electrical connector (1).

- Install the seat cushion and cover assembly. Refer to => [ Seat Cushion and Cover ] Seat Cushion and Cover.

- Install the third row power folding seat. Refer to => [ Seat ] Seat.

- Perform the third row power folding seat recliner calibration. Refer to => [ Third Row Power Folding Seat Recliner Calibration ] Third Row Power Folding Seat Recliner Calibration.