Manual Temperature Control

B1003 - Panel Mode Switch Request Input Circuit/Performance

For a complete wiring diagram, refer to.

Theory of Operation

The switch input changes when the switch is pushed down. A stored DTC indicates that the panel mode switch was stuck in a pushed position for more than 10 minutes, but has since returned to its normal state. An active DTC indicates that the panel mode switch is stuck in a pushed position. An active DTC will prevent proper A/C mode switch and status indicator function.

• When Monitored: With the ignition on.

• Set Condition: If the panel mode switch is detected in a pushed position for more than 10 minutes.






Test Step 1 - Inspect the A/C Heater Control for Damage

• Inspect the A/C heater control for damage.

Is the A/C heater control damaged?

Yes

• Replace the A/C heater control.

• Perform the HVAC Verification Test. Refer to => Non-DTC Based Diagnostics. HVAC Verification Test

No

• Go to Test Step 2 => [ Test Step 2 - Inspect for an Object or Substance Causing the Panel
Mode Switch to Stay or Stick in a Pushed Position ]

Test Step 2 - Inspect for an Object or Substance Causing the Panel Mode Switch to Stay or Stick in a Pushed Position

• Inspect the A/C heater control for anything that would cause the panel mode switch to stay or stick in a pushed position.

Is anything present that would cause the panel mode switch to stay or stick in a pushed position?

Yes

• Repair as necessary.

• Replace the A/C heater control.

• Perform the HVAC Verification Test. Refer to => Non-DTC Based Diagnostics. HVAC Verification Test

No

• Go to Test Step 3 => [ Test Step 3 - Check for Normal Panel Mode Switch and Status Indicator
Function ]

Test Step 3 - Check for Normal Panel Mode Switch and Status Indicator Function

• Turn the ignition ON.

• Set the blower control to any position except off.

• Press the A/C request switch ON.

• Press the panel mode switch.

Does the panel mode status indicator show the correct position?

Yes

• Go to Test Step 4 => [ Test Step 4 - Verify that the DTC is Still Active ].

No

• Replace the A/C heater control.

• Perform the HVAC Verification Test. Refer to => Non-DTC Based Diagnostics. HVAC Verification Test

Test Step 4 - Verify that the DTC is Still Active

• With the scan tool, erase HVAC DTCs.

• Turn the ignition OFF, wait 10 seconds, and then turn the ignition ON. Wait 10 minutes before proceeding.

• With the scan tool, read HVAC DTCs.

Does the scan tool display this DTC?

Yes

• Replace the A/C heater control.

• Perform the HVAC Verification Test. Refer to => Non-DTC Based Diagnostics. HVAC Verification Test

No

• Replace the A/C heater control.

• Perform the HVAC Verification Test. Refer to => Non-DTC Based Diagnostics. HVAC Verification Test