11-Adjustable Pedal Sensor - Circuit Short to Ground
B1ED1-11-Adjustable Pedal Sensor - Circuit Short To Ground
For a complete wiring diagram, refer to.
• When Monitored: Continuously.
• Set Condition: The Memory Seat Module detects a low signal circuit voltage that is not within voltage specification from the Adjustable Pedals Sensor.
Test Step 1 - DTC ACTIVE?
• This DTC must be active for the results of this test to be valid.
• Turn the ignition on.
• With the scan tool, record and erase DTCs.
• Cycle the ignition switch from off to on.
• Cycle the Adjustable Pedals Switch forward and rearward.
• With the scan tool, read DTCs.
Does the scan tool display: B1ED1-11-ADJUSTABLE PEDAL SENSOR- CIRCUIT SHORT TO GROUND?
Yes
• Go to Test Step 2 => [ Test Step 2 - CHECK CONNECTOR/TERMINAL FOR DAMAGE ]
No
• Perform the APS Intermittent Condition Test. Refer to => Non-DTC Based Diagnostics. APS Intermittent Condition Test
Test Step 2 - CHECK CONNECTOR/TERMINAL FOR DAMAGE
• Check all terminals for broken, bent, pushed out, or corroded terminals.
• Turn the ignition off.
• Inspect the Memory Seat Module C1 harness connector, Adjustable Pedals Motor, and Adjustable Pedals Motor harness connector.
Is the Adjustable Pedals Sensor or any of the connectors/terminals damaged?
Yes
• Repair as necessary.
• Perform the APS Verification Test. Refer to => Non-DTC Based Diagnostics. APS Verification Test
No
• Go to Test Step 3 => [ Test Step 3 - CHECK (G13) ADJUSTABLE PEDALS SENSOR SUPPLY CIRCUIT
FOR A SHORT TO GROUND ]
Test Step 3 - CHECK (G13) ADJUSTABLE PEDALS SENSOR SUPPLY CIRCUIT FOR A SHORT TO GROUND
• Disconnect the Memory Seat Module C1 harness connector.
• Disconnect the Adjustable Pedals Motor harness connector.
• Using a 12-volt test light connected to 12-volts, probe the (G13) Adjustable Pedals Sensor Supply circuit at the Memory Seat Module C1 harness connector.
Does the test light illuminate brightly?
Yes
• Repair the (G13) Adjustable Pedals Sensor Supply circuit for a short to ground.
• Perform the APS Verification Test. Refer to => Non-DTC Based Diagnostics. APS Verification Test
No
• Replace and reprogram the Memory Seat Module.
• Perform the APS Verification Test. Refer to => Non-DTC Based Diagnostics. APS Verification Test