Right Power Sliding Door Module
B210B - System Voltage High
For a complete wiring diagram, refer to.
• When Monitored: At all times.
• Set Condition: When the TIPM sends a message to the power sliding door module that the input voltage of the vehicle is above 16 volts for over 15 seconds, this code will set.
Test Step 1 - Check Engine DTCs
• With the scan tool, read engine DTCs.
Are there any battery or charging system DTCs present?
No
• Go to Test Step 2
Yes
• Refer to symptom list for problems related to engine.
Test Step 2 - Test for an Intermittent Condition
• With the scan tool, record and erase DTCs.
• Start the engine and run for two minutes.
• With the scan tool, check for DTCs.
Does the scan tool display B210B - System Voltage High?
Yes
• Go to Test Step 3
No
• The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior
Test Step 3 - Check the Power Sliding Door Track Harness
• Stop the engine.
• Turn the ignition ON.
• Using the scan tool, read and record the battery voltage of the power sliding door module.
• At this time it will be necessary to remove the power sliding door drive unit assembly from the vehicle.
• Turn the ignition OFF.
• Remove the power sliding door drive unit assembly from the vehicle.
• Remove the power sliding door module from the track assembly.
• Disconnect the power sliding door module connector.
• Connect the C382/3 body 4 way harness connector.
• Turn the ignition ON.
• Using a voltmeter, connect one end to the fused B+ circuit and the other end to the ground in the power sliding door module 6 way connector.
Is the measured voltage differing from the scan tool voltage by more than one (1.0) volt?
Yes
• Replace the power sliding door module.
• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior
No
• Test complete.
• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior