Left Power Sliding Door Module

B210E - Battery Voltage High

For a complete wiring diagram, refer to.

• When Monitored: At all times.

• Set Condition: When the power sliding door module detects input voltage more than 16.5 volts for more than 15 seconds, this code will set.






Test Step 1 - Check Engine DTCs

• Ensure the battery is fully charged and serviceable before proceeding.

• With the scan tool, read engine DTCs.

Are there any engine DTCs present?

No

• Go to Test Step 2

Yes

• Refer to symptom list for problems related to engine.

Test Step 2 - Test for an Intermittent Condition

• With the scan tool, record and erase DTCs.

• Start the engine and run for two minutes.

• With the scan tool, check for DTCs.

Does the scan tool display B210E - Battery Voltage High?

Yes

• Replace the power sliding door module.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

No

• The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior