RKE FOB 3 Performance - RKE Transmitter

B2204 - ECU Configuration Mismatch

For a complete wiring diagram, refer to.

Theory of Operation

The Wireless Ignition Node (WIN) must be configured for various parameters such as model year and vehicle line, after a service replacement. The WIN checks for the proper configuration by comparing the values stored to those sent out on the serial data bus. The repair of this fault does not involve any external circuitry and centers on verifying the module is configured correctly.

• When Monitored: The WIN checks the feature configuration at power up during the initialization process, and continuously through the ignition cycle.

• Set Condition: This DTC sets when the WIN detects a mismatch between the current configuration of the module and information sent out on the serial data bus. Once set, this DTC is latched for the entire ignition cycle.






Test Step 1 - DETERMINE ACTIVE OR STORED DIAGNOSTIC TROUBLE CODE (DTC)

Is the DTC active or stored?

WIN - ACTIVE DTC

• Go to Test Step 2

WIN - STORED DTC

• Perform the WIN Verification Test. Refer to => Non-DTC Based Diagnostics. Wireless Ignition Node Verification Test

Test Step 2 - REPLACE THE WIN

• Ensure the part number of the replacement module is the correct part number for the vehicle.

View Repair

Repair

• Replace the Wireless Ignition Node.

• Perform the WIN Verification Test. Refer to => Non-DTC Based Diagnostics. Wireless Ignition Node Verification Test

• Technicians must use the scan tool to perform the WIN Programming procedure after a module replacement.