B222C: Diagnosis and Testing

B222C - Vehicle Configuration Not Programmed

For a complete wiring diagram, refer to.

• When Monitored: With the ignition ON.

• Set Condition: The totally integrated power module is not configured correctly to the vehicle.






Test Step 1 - Test For Active DTCs

• With the scan tool, read the active DTCs.

• Cycle the ignition switch from OFF to ON at least 5 times, leaving the ignition ON for a minimum of 90 seconds per cycle.

• With the scan tool, read the active DTCs.

Does the scan tool display this DTC as active?

Yes

• Go to Test Step 2.

No

• If the DTC is stored, test for an intermittent condition. Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.

Test Step 2 - Configure the TIPM to the Vehicle

• With the scan tool enter program network configuration and program the TIPM to the vehicle configuration.

• With the scan tool, erase TIPM DTCs.

• Cycle the ignition switch from OFF to ON at least 5 times, leaving the ignition ON for a minimum of 90 seconds per cycle.

• With the scan tool, read the Active DTCs.

Does the scan tool display this DTC as active?

Yes

• Inspect the wiring and connectors for damage or shorted circuits. If OK, replace and program the totally integrated power module.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

No

• Repair is complete.