C2206

C2206 - Vehicle Configuration Mismatch

For a complete wiring diagram, refer to

• When Monitored: With the ignition ON.

• Set Condition: When the anti lock brake module detects the signal from the gateway module relevant for vehicle characteristic is missing for a period greater than the specified fault duration.






Test Step 1 - Test for DTC C2206 - Vehicle Configuration Mismatch

• This DTC must be active for the results of this test to be valid. Diagnose and repair any communication DTCs in the FCM before continuing with this test.

• Diagnose and repair any system under voltage or over voltage DTCs before continuing with this test.

• Turn the ignition ON.

• With the scan tool, read the DTCs.

• With the scan tool, read and record environmental data to help identify the conditions in which the DTC was set.

• With the scan tool, erase the DTCs.

• Cycle the ignition switch OFF then ON.

• With the scan tool, read the DTCs.

Does the scan tool display C2206 - Vehicle Configuration Mismatch?

Yes

• With the scan tool select FCM under ECU selection then Misc Functions and restore vehicle configuration.

No

• Perform the ABS Intermittent Condition Test. Refer to => Non-DTC Based Diagnostics. ABS Intermittent Condition Test