Memory Seat Module
U0011-00-CAN Interior Bus Off Performance
For a complete wiring diagram, refer to.
• When Monitored: Continuously.
• Set Condition: The Memory Seat Module detects the (D265) CAN IHS BUS (125K)(+) circuit or (D264) CAN IHS BUS (125K)(-) circuit open.
Test Step 1 - TEST FOR INTERMITTENT CONDITION
• Turn the ignition on.
• With the scan tool, record and erase MSMD DTCs
• Cycle the ignition from on to off three times.
• Turn the ignition on.
• With the scan tool, read active MSMD DTCs.
Does the scan tool display this DTC as active?
Yes
• Go to Test Step 2 => [ Test Step 2 - (D265) CAN IHS BUS (125K)(+) CIRCUIT OPEN ]
No
• The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
• Perform the Body Verification Test. Refer to => Non - DTC Based Diagnostics. Body Interior
Test Step 2 - (D265) CAN IHS BUS (125K)(+) CIRCUIT OPEN
• Turn the ignition off.
• Disconnect the Memory Seat Module C1 harness connector.
• Measure the voltage between the (D265) CAN IHS BUS (125K)(+) circuit and ground.
Is there any voltage present?
Yes
• Go to Test Step 3 => [ Test Step 3 - (D264) CAN IHS BUS (125K)(-) CIRCUIT OPEN ]
No
• Repair the (D265) CAN IHS BUS (125K)(+) circuit for an open.
• Perform the Body Verification Test. Refer to => Non - DTC Based Diagnostics. Body Interior
Test Step 3 - (D264) CAN IHS BUS (125K)(-) CIRCUIT OPEN
• Turn the ignition off.
• Disconnect the Memory Seat Module C1 harness connector.
• Measure the voltage between the (D264) CAN IHS BUS (125K)(-) circuit and ground.
Is there any voltage present?
Yes
• Inspect the wiring and connectors for damage or shorted circuits. If ok, replace the Memory Seat Module.
• Perform Power Seat System Verification Test. Refer to => Non - DTC Based Diagnostics. Power Seat System Verification Test
No
• Repair the (D264) CAN IHS BUS (125K)(-) circuit for an open.
• Perform the Body Verification Test. Refer to => Non - DTC Based Diagnostics. Body Interior