Passive Entry Antennas, Right Quarter Panel

Right Quarter Panel







Removal

- Disconnect the battery negative cable.

- Remove the trim panel from the right quarter inner panel (1).

- Disconnect the body wire harness connector (2) from the Low Frequency (LF) antenna (3) connector receptacle.

- Remove the two screws (4) that secure the LF antenna and bracket unit to the right quarter inner panel over the park assist module (5).

- Remove the LF antenna from the right quarter inner panel.

Installation







- Check to be certain that the two plastic nuts (6) are in good condition and properly installed in the right quarter inner panel (1).

- Position the Low Frequency (LF) antenna (3) to the right quarter inner panel over the park assist module (5).

- Install and tighten the two screws (4) that secure the LF antenna to the right quarter inner panel. Tighten the screws securely.

- Connect the body wire harness connector (2) to the LF antenna connector receptacle.

- Install the trim panel onto the inside of the right quarter inner panel.

- Connect the battery negative cable.