Heated Seats Module

Heated Seats Module

• Vehicles equipped with the heated seat option utilize a low voltage cut-off feature. This feature turns off power to the heated seat system anytime vehicle voltage is below 11.7 volts or above 15.5 volts. Be certain to check the vehicle electrical system for proper voltage anytime the heated seat system appears inoperative.

• If a Diagnostic Trouble Code (DTC) can not be verified, it is a good indication that an INTERMITTENT fault condition may be present. To help find an intermittent problem, sit in the seat in question and move around the heating elements within the seat while testing continuity. also wiggle the heated seat wire harness and electrical connectors while testing continuity.

• For complete circuit diagrams, see Wiring Information. Wiring Information includes wiring diagrams, connector pin-out and location views, details of wire harness routing and retention, splice and ground locations and proper wire and connector repair procedures.

- Check the ignition switch fuse in the Totally Integrated Power Module. Repair as necessary.

- Check the vehicles battery open-circuit voltage and charging system performance. If the vehicle's electrical system is defective or weak it may not be suppling sufficient energy to operate the heated seat system.

- Using a scan tool, check for any Diagnostic Trouble Codes (DTCs) related to the A/C-heater control, Cabin Compartment Node (CCN) and the rear door modules. If any DTCs are found, repair as necessary.

- If there are no DTCs and the heated seat system does not operate, see wiring information and repair as necessary.

- If wiring is OK, replace the Heated Seat Module (HSM).