Third Row Power Folding Bench Seat, Folding Seat Module
Folding Seat Module
Installing
• The third row power folding seat module is located in the 60 percent seat cushion pan. The following steps should be performed on the 60 percent seat only.
- Remove the 60 percent third row power folding seat. Refer to => [ Seat ] Seat.
- Remove the seat cushion and cover assembly to expose the seat cushion pan (2). Refer to => [ Seat Cushion and Cover ] Seat Cushion and Cover.
- Remove the push pin retainers (1) securing the module and bracket (4) to the seat pan (2).
- Disconnect the module electrical connectors (3).
- Remove the third row power folding seat module from the module bracket.
- Push the module (1) forward in order to release the tabs (4).
- Continue to push the module forward releasing the knobs (2) from the module bracket (3).
- Separate the module from the bracket.
Installing
- Position the third row power folding seat module (1) onto the module bracket (3). Ensure the knobs (2) and tabs (4) are aligned with the appropriate slots in the bracket (3).
- Push the module into the bracket until the knobs (2) and tabs (4) are fully seated.
- Connect the module (4) electrical connector (3).
- Position the third row power folding seat module and bracket (4) onto the seat pan (2) and secure with the push pin retainers (1).
- Install the seat cushion and cover assembly. Refer to => [ Seat Cushion and Cover ] Seat Cushion and Cover.
- Install the third row power folding seat. Refer to => [ Seat ] Seat.
- Perform the third row power folding seat recliner calibration. Refer to => [ Third Row Power Folding Seat Recliner Calibration ] Third Row Power Folding Seat Recliner Calibration.