Pressure Control Solenoid
Pressure Control Solenoid
Removing
- Remove the engine cover.
- Remove the battery tray.
- Remove the relay (1) at the core support.
- Drain the cooling system.
- Reposition the clamps (1) for the upper radiator hose (2).
- Remove the upper radiator hose.
- Remove the bolts (1) securing the power steering lines (2).
- Remove the shift cable (1) from the manual lever (2).
- Remove the front sound damper cover fasteners (1) and cover (2).
- Remove the valve body oil pan (1) upper bolts.
- Disconnect the solenoid pack electrical connector (2) at the valve body oil pan (1).
- Raise and suitably support the vehicle.
- Remove the front left wheelhouse liner screws and fold the liner (2) back.
- Turn the wheel (3) fully to the left.
- If equipped with the 3.8L engine, remove the exhaust crossover pipe.
- Remove the bolt (2) for the ground cable (3).
- Remove the clip (1) at the valve body oil pan.
- Move the ground cable (3) away from the valve body oil pan.
- Remove the pressure tap plug (2) from the valve body oil pan.
- Remove the valve body oil pan lower bolts (1) and drain the transaxle fluid.
- Remove the valve body oil pan.
- Remove the pressure control solenoid bolt (1).
- Remove the pressure control solenoid (2) from the valve body.
Installing
- Install the pressure control solenoid (2) to the valve body.
- Install the pressure control solenoid bolt (1). Tighten the bolt to 6 Nm (53 in lbs).
- Install the valve body oil pan, use a bead of RTV sealant.
- Install the valve body oil pan lower bolts (1) and tighten the bolts to 6 Nm (53 in lbs).
- Install the pressure tap plug (2) to the valve body oil pan and tighten the plug to 6 Nm (53 in lbs).
- Lower the vehicle.
- Connect the solenoid pack electrical connector (2) to the valve body oil pan (1).
- Raise the vehicle.
- Install the valve body oil pan (1) lower bolts and tighten the bolts to 6 Nm (53 in lbs).
- Position the ground cable (3) and install the bolt (2). Tighten the bolt to 10 Nm (89 in lbs).
- Install the clip (1) to the valve body oil pan.
- Install the front sound damper cover (2) and fasteners (1).
- If equipped with the 3.8L engine, install the exhaust crossover pipe.
- Move the left side wheelhouse liner (2) into place and install the screws.
- Lower the vehicle.
- Install the bolts (1) securing the power steering lines (2) and tighten the bolts to 10 Nm (89 in lbs).
- Install the shift cable (1) to the manual lever (2).
- Install the upper radiator hose (2) and position the clamps (1).
- Fill the cooling system.
- Install the relay (1) at the core support.
- Install the battery tray.
- Fill the transmission with fluid and road test.