Heating and A/C Controls

Heating and A/C Controls

Removing

• The controls consist of two separable housings. Before removing controls, bring rotary buttons into the following position:

• Heater control to "cold"

• Blower to "0"

• Air flow direction to "footwell"

- Remove the trim from the heater and A/C controls. Refer to Storage Compartments, Covers and Trim.






- Remove the bolts - 2 - (4.2 x 45) and - 3 - (4.2 x 16) and the controls - 1 - from the center console.

Tightening specification for the bolts - 2 - and - 3 -: 1.5 +/- 0.2 Nm.






- Release the connector - A - by pulling it in the - direction of arrow -.

- Press connector release - B - toward the connector - arrow 2 - and disconnect the connector - C -.

- Disconnect the connector - D -.

Installing

Installation is performed in reverse order of removal, make sure when doing so that the rotary buttons have the same position as when removing.