Instrument Cluster

Instrument Cluster

• If a new instrument cluster is installed in the vehicle, the control module for the instrument cluster must be set to the various equipment characteristics and corresponding country version.

• In order to adapt the integrated anti-theft immobilizer to the Engine Control Module (ECM), data from ECM must be stored in the replacement instrument cluster.

• Also, adapt all keys after installing a new instrument cluster and perform a basic setting of the steering angle sensor.

• Prior to replacing the instrument cluster, perform the procedure => [ Instrument Cluster Adaptation/Replacing ] Component Tests and General Diagnostics to check the data stored in the control module.

Removing

- Turn off the ignition and all electric consumers and remove the key.

• It is not necessary to remove the steering wheel.

- Pull steering wheel all the way out and lock it in the lowest position.

- Loosen the steering column trim gap cover from the instrument panel.

- Remove mounting bolts - arrows - of instrument cluster.






• The fixed electrical connection to the instrument cluster is disconnected automatically when the cluster is pulled out of the instrument panel opening. Harness connector is installed permanently in vehicle and is disconnected automatically when pulling out instrument cluster.

- Pull instrument cluster out of instrument panel.

Installing

Install in reverse order of removal.