Leak Detection Pump (V144)

Leak Detection Pump (V144)

Removing

- Remove the right rear wheel housing liner.

- Disconnect the vacuum line - 1 -.






- Disconnect the connector - 2 -.

- Disconnect the vent line - 3 - by pressing release button.

- Remove the nuts - arrows -.

- Disengage the leak detection pump with bracket.

Installing

Installation is performed in the reverse order of removal, noting the following:

• The vent line - 3 - must engage audibly.

- Install the right rear wheel housing liner.

Tightening specifications, refer to => [ EVAP System Components ] EVAP System Component Overviews.