Ignition Switch

Ignition Switch


Follow the procedure in the repair information when disconnecting and connecting the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

Removing

- Disconnect the battery. Refer to => [ Battery, Disconnecting ] Battery, Disconnecting.


• Risk of airbag deployment!

• The airbag could deploy if the airbag unit is handled incorrectly.

• Follow all Safety Precautions when working with airbags.

- Remove steering column trim. Refer to Storage Compartments, Covers and Trim.

- Disconnect harness connector - 2 - from ignition/starter switch - 1 -.






- Release ignition/starter switch using a small screwdriver - arrows -.

- Pull out ignition/starter switch - 1 - from steering lock housing.

Installing

- Insert ignition/starter switch into steering lock housing until it engages audibly.

- Insert ignition key into lock cylinder and turn it into position "Drive".






• Key must be located in "Drive" position.

Key positions of lock cylinder:

1 Position "Off"
2 Position "Run"
3 Position "Start"

- Install all the components in reverse order of removal.