Shift Unit

Shift Unit

Special tools, testers and auxiliary items required

• Thrust Piece (T10203)






1 Shift Unit

• Consisting of the shift shaft and the shift cover.

• The components cannot be separated from each other.

2 O-ring

• Insert in the groove in the shift cover.

• Install using transmission fluid.

• Always replace

3 Alignment Sleeve

• For centering the shift unit to the transmission housing.

4 Selector Shaft Seal

• Removing and installing, refer to => [ Selector Shaft Seal ] Selector Shaft Seal.

5 Cap

• For the transmission ventilation.

6 Locking Pin

• For adjusting the shift mechanism. Refer to => [ Shift Mechanism, Adjusting ] Shift Mechanism, Adjusting.

• Removing, refer to => [ Removing the Locking Pin from the Shift Cover ].

• Installing, refer to => [ Pressing the Locking Pin into the Shift Cover ].

7 Bushing

• For the gear shift shaft.

• Removing and installing, see - item 5 - in => [ Transmission Housing ] Transmission Housing.

Removing the Locking Pin - A - from the Shift Cover





- Remove the outer part of the locking pin.

- Then carefully pry out the locking pin with a screwdriver.

Pressing the Locking Pin - A - into the Shift Cover





Installed position:

The mark - arrow - faces toward the upper part of the gear shift shaft.