Trim Panel

Trim Panel

Removing

• The window guide seal - 2 - is attached to the trim - 1 - with two-sided adhesive tape.

• If the adhesive tape is damaged, then a new window guide must be installed.

- Pull window guide - 4 - out of mount - arrows a -.





- Pull off seal of window guide - 2 - carefully from the trim panel - arrow b -.

- Remove the screws - 3 - and pull the trim - 1 - under the window shaft strip upward - arrows c -.

- Pull the trim - 1 - in the direction of the B-pillar - arrows d -.

Installing

• Inspect the spring clamps - 5 -, the seal - 3 - and the adhesive tape - 4 - for damage and completeness. Replace parts if necessary.

- Slide the trim - 1 - in - arrow a - on to the window frame.





- Press the trim downward - arrow b - behind the window recess seal.

- Tighten bolts - 2 -, tightening specification: 2 Nm.

- Place the window guide - 6 - into the bracket - arrow c -.

- Coat the adhesive strip with the rubber seal adhesive (D 002 100).

- Press the window guide seal - 3 - evenly on to trim.