Windshield Wiper System

Windshield Wiper System


Follow the procedure in the repair information when disconnecting and connecting the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

• Additional information:

Refer to the Owner's Manual.

The Wiper Motor Control Module (J400) is integrated with the Windshield Wiper Motor (V). If the Wiper Motor Control Module (J400) is to be exchanged, read the coding beforehand and then code the new Wiper Motor Control Module (J400) with this value.

To remove wiper blades, wiper arms must be driven into "service/winter position". The "service/winter position" is activated by pressing the windshield wiper lever in the "one-touch wiping" position within 10 seconds after switching the ignition off. Refer to the Owner's manual.






DTC Recognition and Display

Vehicle Electrical System Control Module (J519) is equipped with On Board Diagnostics (OBD) which assists troubleshooting.

Use the Vehicle Diagnostic Tester under "Guided Fault Finding".