A/C Compressor Drive Plate

A/C Compressor Drive Plate

- Remove drive plate with overload safeguard. Refer to => [ Drive Plate with Overload Protection ] Drive Plate with Overload Protection.

Removing

- Loosen the drive plate - C - by rotating it in the direction of the arrow - D - using a commercially available band wrench with webbed band. Counterhold the A/C compressor shaft - A - with a counterhold tool - B -.





• Depending on the versions of the compressor the compressor shafts are different, an open end wrench or a Socket Wrench (T10001/10) from the Shock Absorber Set (T10001) or retainer (3079) must be used to counterhold.

Installing

- When installing, coat the rubber elements - B - lightly using soapy water as a lubricant.





- Insert the rubber elements - B - in the drive plate - A - as shown in the illustration.

- Insert the drive plate - A - with the rubber elements - B - into the drive plate - C - until it makes contact with the compressor shaft.

• This illustration shows the rubber element - B - in version "1". Rubber elements - B - of version "2" are joined to each other at top.

- Install the drive plate - C - on the A/C compressor shaft - A - by rotating it in the direction of the arrow - E -.





- Tighten the drive plate - C - to 30 Nm by turning it in the direction of arrow - E - with a standard band wrench with a webbed band. Counterhold the A/C compressor shaft - A - with a counterhold tool - B -.

• Depending on the versions of the compressor the compressor shafts are different, an open end wrench or a Socket Wrench (T10001/10) from the Shock Absorber Set (T10001) or Retainer (3079) must be used to counterhold.