Auxiliary High Beam Bulb

Auxiliary High Beam Bulb

• Left High Beam Headlamp (M30) and Right High Beam Headlamp (M32) can be checked via output Diagnostic Test Mode (DTM) of Vehicle Electrical System Control Module (J519). Refer to => [ Vehicle Electrical System, Output Diagnostic Test Mode ] Scan Tool Testing and Procedures.

• Illustrations depict replacement of High Beam Headlamp Lamp at left headlamp.

• Procedure to replace Left High Beam Headlamp (M30) and Right High Beam Headlamp (M32) is the same.

Removal

- Turn off the ignition and all electric consumers and remove the key.

- Remove headlamp. Refer to => [ Headlamps ] Headlamps.

- Remove cover cap - arrow - at headlamp housing.






- Separate the connector - arrow -.






- Compress and release the spring clip - arrow -.






- Carefully remove lamp for high beam headlamp.

Installation

Install in reverse order of removal. Note the following:

• When installing cap, ensure proper seating. It is destroyed by entry of water into headlamp.

• Do not touch the glass of the light bulb, when installing. Your fingers will leave traces of grease on the glass which, when the light bulb is switched on, will evaporate and cloud the glass.

- Insert new High Beam Lamp so that retaining tabs lie in cut-out in reflector.

- Check headlamp for function.

- Check the headlamp adjustment. Refer to Maintenance Procedures; Rep. Gr. 03.