Front Turn Signal Bulb

Front Turn Signal Bulb

• Left Front Turn Signal Lamp (M5) and Right Front Turn Signal Lamp (M7) can be checked via output Diagnostic Test Mode (DTM) of Vehicle Electrical System Control Module (J519). Refer to => [ Vehicle Electrical System, Output Diagnostic Test Mode ] Scan Tool Testing and Procedures.

• Illustrations depict replacement of Front Turn Signal Light at left headlamp.

• Procedure to replace Left Front Turn Signal Lamp and Right Front Turn Signal Lamp is the same.

Removal

- Turn off the ignition and all electric consumers and remove the key.

- Remove headlamp. Refer to => [ Headlamps ] Headlamps.

- Remove cover cap - arrow - at headlamp housing.






- Disconnect connector - arrows - at holder of Front Turn Signal Light.






- Turn socket of Front Turn Signal Light in - direction of arrow -.






- Remove socket with Front Turn Signal Light from reflector.

- Press Front Turn Signal Light into socket and turn Front Turn Signal Light toward left.

- Remove Front Turn Signal Light from socket.

Installation

Install in reverse order of removal. Note the following:

• When installing cap, ensure proper seating. It is destroyed by entry of water into headlamp.

• Do not touch the glass of the light bulb, when installing. Your fingers will leave traces of grease on the glass which, when the light is switched on, will evaporate and cloud the glass.

- Check headlamp for function.

- Check the headlamp adjustment and correct it if necessary. Refer to Maintenance Procedures; Rep. Gr. 03.