Procedures

Turbocharger Servo Motor Linkage, Lubricating

Lubricating Servo-Motor Linkage Applies to:

1. Turbocharger (TC) 1 Servo-Motor -V280- for cylinder bank 1 (right engine side).
2. Turbocharger (TC) 2 Servo-Motor -V281- for cylinder bank 2 (left engine side).

- Remove lower engine cover (noise insulation). Refer to=> [ Lower Engine Cover, Removing and Installing ] Lower Engine Cover, Removing and Installing.

Turbocharger Servo Motor -Right Engine Side-

Installed location: Wheel housing, right front, above the steering boot, between the front longitudinal member and engine block - arrow A -.





- Lubricate the pivot of the servo motor shaft and linkage - arrows A - and - B -.





Use Lubricant (G 052 112 A3) or equivalent.

Turbocharger Servo Motor -Left Engine Side-

Installed location: Left front, between the steering and housing of front final drive, above the coolant hoses - arrow A -.





- Lubricate the pivot of the servo motor shaft and linkage - arrows A - and - B -.





Use Lubricant (G 052 112 A3) or equivalent.