Access/Start Authorization Control Module (J518)

Access/Start Authorization Control Module (J518)

Removal


When disconnecting battery, procedure must always be followed as described in the repair manual => [ Disconnecting Sequence ] One-Battery Layout with Auxiliary Battery and Two Battery Layout, Disconnecting and Connecting. Not adhering to sequence will result in the deactivation of Main Battery Switch -E74- and subsequent damage to electrical system components.

- Disconnect the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove lower storage compartment on driver's side.

- Push locking hooks of bracket outward - arrows B - and pull Access/Start Authorization Control Module (J518) - 1 - behind bracket forward - arrow A -.






- Release - arrow A - locking mechanism - 1 - of multi-pin harness connector - 2 -.






- Disconnect - arrow B - multi-pin harness connector - 2 - from Access/Start Authorization Control Module.

- Disengage multi-pin harness connector - 3 - and disconnect it from Access/Start Authorization Control Module - arrow C -.

- Remove Access/Start Authorization Control Module from bracket.

Installation

Install in reverse order of removal. Note the following:

- The strap - 1 - for Access/Start Authorization Control Module must first be inserted into guide at top.

- Next, strap - 2 - is clipped into bracket.






• If Access/Start Authorization Control Modulen is replaced, work sequence=> [ Access/Start Authorization Control Module, Replacing ] Access/Start Authorization Control Module, Replacing must be performed.