Headlamp Range Control Positioning Motor

Headlamp Range Control Positioning Motor

• If the motors are removed and installed again or replaced, check the headlamp adjustment and adjust it again if necessary. Refer to Maintenance Procedures; Rep. Gr. 03.

• Illustrations depict replacement of headlamp beam adjusting motor at left headlamp.

• Procedure to replace Left Headlamp Beam Adjustment Motor (V48) and Right Headlamp Beam Adjustment Motor (V49) is the same.

Removal

- Turn off the ignition and all electric consumers and remove the key.

- Remove headlamp. Refer to => [ Headlamps ] Headlamps.

- Remove screw - 1 - and press adjusting shaft for low beam and high beam height adjustment - 2 - in - direction of arrow - out of guide.






- Pull adjusting shaft for low beam and high beam height adjustment - 2 - out of headlamp housing.

- Press wire bracket - 1 - to the side in - direction of arrow - and remove cover cap - 2 -.






- Disconnect connector - 3 -.






- Remove screws - 1 -.

- Press the adjusting motor - 2 - in - direction of arrow - in order to pull out adjusting axle ball head laterally out of ball head mount at reflector.

- Remove adjusting motor - 2 - from headlamp housing.

Installation

Install in reverse order of removal. Note the following:

• When installing cap, ensure proper seating. It is destroyed by entry of water into headlamp.

- Insert adjusting axle of adjusting motor - 1 - carefully into ball head guide - arrow -.






- Check headlamp for function.

- Check the headlamp adjustment and correct it if necessary. Refer to Maintenance Procedures; Rep. Gr. 03.