High Beam Bulb

High Beam Bulb

• Left High Beam Headlamp (M30) and Right High Beam Headlamp (M32) can be checked via output Diagnostic Test Mode (DTM) of Vehicle Electrical System Control Module (J519). Refer to => [ Vehicle Electrical System, Output Diagnostic Test Mode ] Scan Tool Testing and Procedures.

• The illustrations show the procedure for removing and installing the right high beam headlamp bulb.

• The same procedure is used to remove and install the left high beam headlamp and right high beam headlamp.

Removal

- Turn off the ignition and all electric consumers and remove the key.

- Remove headlamp. Refer to => [ Headlamps ] Headlamps.

- Remove the cap - 1 - from the rear side of the headlamp.






- Turn the high beam headlamp - 1 - in the - direction of the arrow - and remove it from the reflector. Be careful of the connected wires when doing this.






- Release and disconnect the connector - 1 - and the remove high beam headlamp - 2 -.






• The lamp for fog light is joined permanently to lamp socket and cannot be replaced separately.

High beam headlamp bulb : H9 12 V, 65 W

Installation

Install in reverse order of removal. Note the following:


When installing cap, ensure proper seating. It is destroyed by entry of water into headlamp.

• Do not touch the glass of the light bulb, when installing. Your fingers will leave traces of grease on the glass which, when the light is switched on, will evaporate and cloud the glass.

- Check headlamp for function.

- Check the headlamp adjustment and correct it if necessary. Refer to Maintenance Procedures; Rep. Gr. 03.