Ribbed Belt Pulley on Generator, Air Cooled

Ribbed Belt Pulley on Generator, Air Cooled

Special tools, testers and auxiliary items required

• Socket (VAS 3310)

• Torque Wrench (V.A.G 1331/)

• Torx Screwdriver Insert (V.A.G 1603/1)

• Digital Torque Wrench (V.A.G 1756 A)

Removal

- Remove generator. Refer to => [ Generator, Air Cooled ] Generator, Air Cooled.

- Tighten the generator in a vise at the mounting points.

- Use the (VAS 3310) to remove the ribbed belt pulley nut from the generator shaft.






- Turn counter-clockwise to loosen the nut.

Installation

Install in reverse order of removal. Note the following:

- Tighten the threaded connection between the ribbed belt pulley and generator shaft 25 Nm and 60° angle of rotation.