Rear Wheel Housing Liner

Rear Wheel Housing Liner

• The following describes removing and installing the left wheel housing liner. Removing and installing the right wheel housing liner is identical.

• Due to equipment variations, small deviations must be considered during removal and installation.

Removing






- Remove the wheel.

- If present, remove the sill panel cover, refer to => [ Sill Panel Cover Assembly Overview ] Sill Panel Cover Assembly Overview.

- If there is no sill panel cover installed, then remove the bolt - 4 -.

- Remove bolts - 3 - (quantity: 9).

- Remove the wheel housing liner - 1 - from the fender.

Installation






• Check the expanding nuts - 2 - damage and replace if necessary.

- Insert the wheel housing liner - 1 - in the fender and adjust it the installed position.

- Secure the mount and wheel housing liner to the fender with the bolt.

- Tighten the bolts - 3 -.

Tightening specification - 3 -: 2 Nm

- If there is no sill panel cover installed, then install and tighten the bolt - 4 -.

Tightening specification - 4 -: 2 Nm

- If equipped, install the sill panel cover, refer to => [ Sill Panel Cover Assembly Overview ] Sill Panel Cover Assembly Overview.

- Install the wheel.