Battery monitoring control module (J367), removing and installing

Battery monitoring control module (J367), removing and installing

The "replacing the battery monitoring control module" procedure must be performed each time before removing the battery monitoring control module (J367) to read the data stored in the battery monitoring control module (J367)=> [ Battery Monitoring Control Module (J367), Replace, Removing and Installing ] Battery Monitoring Control Module (J367), Replace, Removing and Installing.

Special tools, testers and auxiliary items required

• Torque wrench (V.A.G 1331)






Always follow the instructions regarding disconnecting and connecting the battery (A). Refer to => [ Battery (A), Disconnecting and Connecting ] Battery (A), Disconnecting and Connecting.

Removing

- Disconnect the battery (A). Refer to => [ Disconnecting ] Disconnecting.

- Loosen the nut - 4 - a few turns and remove the battery ground cable terminal and the battery monitoring control module (J367) - 3 - from the battery negative pole.






- Disconnect the connector - 5 -.

- Free up the ground wire - 1 -.

- Remove the nut - 2 - and then remove the ground wire and the battery monitoring control module (J367) - 1 -.

Installing

Install in reverse order of removal. Note the following:

- Tighten the threaded connections to the tightening specifications. Refer to => [ Battery Overview ] Battery Overview.

- Connect the battery (A). Refer to => [ Connecting ] Connecting.

The "replacing after starting operations" procedure must be performed after installing the battery monitoring control module (J367) => [ Battery Monitoring Control Module (J367), Replace, Removing and Installing ] Battery Monitoring Control Module (J367), Replace, Removing and Installing.