Operation CHARM: Car repair manuals for everyone.

2.5L Engine






Brake Lamp Switch

Removing

- Disconnect the connector - 1 - and intake hose - 2 -.






- Remove the bolts - 3 - and the intake hose.

- Remove the engine cover from the fasteners first at the front - arrow 1 -, then at the rear on the right side - arrow 2 - and finally at the rear on the left side - arrow 3 - with a quick pull.






- Carefully remove the engine cover at the rear.

- Remove the noise insulation and the impact guard.

- Release and remove the connector - 1 -.






- Remove the bolt - 2 - from the master brake cylinder.

- Remove the brake lamp switch (F) - 3 - from under the master brake cylinder and from the clip - 4 -.

Installing

Install in reverse order of removal. Note the following:

- Install the brake lamp switch in the clip.

Tightening Specification