Procedures

General Repair Information

To perform a problem-free and successful steering gear repair, extreme caution and cleanliness, as well as properly functioning tools are an important requirement. Understandably, general safety guidelines apply when performing repairs.

A series of applicable general notes for individual repair procedures - otherwise listed several times at many points in the repair information - has been collected here. They apply for this repair information.

Steering Gear

• Thoroughly clean connecting points and their surrounding areas before loosening.

• When installing steering gear, make sure centering sleeves are correctly seated between console and steering gear.

• Place removed parts on a clean surface and cover to prevent contamination. Use foils and paper. Only use lint-free cloths!

• Only install clean components: Only unpack replacement parts immediately prior to installation.

• Use exclusively lubricants and sealants marked with part numbers.

• Carefully cover or seal open components, if repairs are not carried out immediately.

Gaskets and Seals

• Always replace the gaskets and seals.

• After removing seals, inspect contact surface on housings and shafts for burrs and damage and repair if necessary.

• Remove all residual sealant of fluid seals from sealing surfaces, no sealant residue must enter the steering gear housing when doing this.

Bolts and Nuts






• Loosen and tighten the screw and nut from the covers and housings diagonally.

• Do not cant but loosen and tighten especially sensitive parts in diagonal manner in stages, e.g. servo motor with control module.

• Torque specifications for unlubricated bolts and nuts are given.

• Always replace self-locking nuts and bolts.

Electrical Components

Surely everyone has been shocked at one time or another when coming into contact with a metal object. The reason for this is the build-up of static electricity in the human body. This charge can lead to functional problems by touching the electrical components of steering gear.

- Touch a grounded object, e.g. a water pipe or a vehicle hoist, before working on electrical components. Do not touch the connector terminals.

Guided Fault Finding, OBD and Test Instruments






• Before performing repairs on the electromechanical steering gear, determine the cause of the damage as closely as possible using the Vehicle Diagnostic Tester in the " Guided Fault Finding", "Vehicle Self-Diagnosis" and "Measurement" modes.