Clutch Housing Overview

Clutch Housing Overview






1 Bushing

• For the selector shafts.

• Always replace if removed.

• Removing, refer to => [ Removing the Selector Shaft Bushing ] Clutch Housing.

• Installing, refer to => [ Installing the Selector Shaft Bushing as Far as the Stop on the Tool ] Clutch Housing.

2 Needle Sleeve

• For the reverse gear shaft.

• Always replace if removed.

• Removing, refer to => [ Removing the Rear Gear Shaft Needle Sleeve from the Clutch Housing ] Clutch Housing.

• Installing, refer to => [ Installing the Rear Gear Shaft Needle Sleeve into the Clutch Housing ] Clutch Housing.

3 Alignment Sleeve

• Quantity: 2

4 Clutch Housing

• When replacing: Adjust the output shafts and differential. Refer to => [ Adjustment Overview ] Adjustment Overview.

5 Cap

• Not on all clutch housings.

6 Input Shaft Seal

• Removing, refer to => [ Removing the Input Shaft Seal ] Clutch Housing.

• Installing, refer to => [ Install the Input Shaft Seal until Flush ] Clutch Housing.

7 Seal

• For the right flange shaft.

• Removing and installing, refer to => [ Right Flange Shaft and Seal ] Right Flange Shaft and Seal.

8 Washer

• For the differential.

• Installed position: The shoulder on the inner circumference faces the seal - item 7 -.

9 Outer Race/Tapered Roller Bearing

• For the differential.

• Removing and installing, refer to => [ Differential ] Service and Repair.

• When replacing: adjusting the differential, refer to => [ Differential, Adjusting ] Differential, Adjusting.

10 Oil Deflector Ring

• Installed position: The shoulder on the hole faces the output shaft.

11 Outer Race/Tapered Roller Bearing

• Output shaft, 1st to 4th gears.

• Removing and installing, refer to => [ Output Shaft, 1st to 4th Gears ] Output Shaft, 1st to 4th Gears.

• When replacing: adjust the output shaft for 1st to 4th gear. Refer to => [ Output Shaft, 1st to 4th Gears, Adjusting ] Output Shaft, 1st to 4th Gears, Adjusting.

12 Outer Race/Tapered Roller Bearing

• Output shaft, 5th, 6th and reverse gears.

• Removing and installing, refer to => [ Output Shaft, 5th, 6th and Reverse Gears ] Output Shaft, 5th, 6th and Reverse Gears.

• When replacing: adjust the output shaft for 5th/6th and reverse gear. Refer to => [ Output Shaft, 5th, 6th and Reverse Gears, Adjusting ] Output Shaft, 5th, 6th and Reverse Gears, Adjusting.

13 Washer

• Output shaft, 5th, 6th and reverse gears.

• Always 0.65 mm thick.

14 Cylindrical Roller Bearing

• For the input shaft.

• Removing and installing, refer to => [ Input Shaft Overview ] Input Shaft Overview.

15 Magnet

• Held in place by the housing joint surface.