Driver Side Instrument Panel Cover

Driver Side Instrument Panel Cover

Removing

- Turn off the ignition.

- Remove the side instrument panel cover on the driver side. Refer to => [ Side Instrument Panel Covers ] Side Instrument Panel Covers.

- Remove the instrument cluster trim panel, refer to => [ Instrument Cluster Trim ] Instrument Cluster Trim.

- Remove the driver side instrument panel vent, refer to => [ Front Instrument Panel Vent ] Front Instrument Panel Vent.

- Push the rotary light switch forward, turn it to the right until it is vertical, pull it out and disconnect the wiring harness.






- Remove the screws - 2 - (1.5 Nm).

- Loosen the driver side instrument panel cover - 1 - from the instrument panel and disconnect the wiring harness from the headlamp range control adjuster (E102).

Installation

- Install in reverse order of removal.

• Check all the fasteners for damage and replace if necessary before installing. Replace any damaged components.