Connecting Cable

Connecting Cable

• Removing and installing on the left side of the vehicle is described here. Removing and installing on the right side is identical.

Removing

The general safety precautions for working on airbag, belt tensioner and battery cut-out units (pyrotechnic components) must be observed. Refer to => [ Airbag, Belt Tensioner and Battery Cut-Out Units General Safety Precautions ] Airbag, Belt Tensioner and Battery Cut-Out Units General Safety Precautions.

- Attach the fixture for seat repair (VAS 6136) to the engine/transmission holder (VAS 6095).

- Remove the front seat. Refer to => [ Front Seat ] Front Seat.

- Secure the seat on the fixture for seat repair (VAS 6136).

- Remove the trim on the tunnel side. Refer to => [ Tunnel Side Trim ] Tunnel Side Trim.

- Remove the backrest adjustment wheel. Refer to => [ Backrest Adjusting Wheel ] Backrest Adjusting Wheel.

- Remove the seat height adjustment handle. Refer to => [ Seat Height Adjustment Handle ] Seat Height Adjustment Handle.

- Remove the trim on the door sill side. Refer to => [ Door Sill Side Trim ] Door Sill Side Trim.

- Remove the backrest. Refer to => [ Front Backrest ] Front Backrest.

- Remove the entry assistance trim panel. Refer to => [ Entry Assistance Trim ] Entry Assistance Trim.

- Remove the cover and the front seat backrest padding. Refer to => [ Front Seat Backrest Cover and Upholstery ] Front Seat Backrest Cover and Upholstery.

- Tilt the bracket - arrow - up as far as the stop and hold it in that position.






- Unhook the connecting cable - 1 - from the bracket - 2 -.

- Push the handle - 1 - all the way forward.






- Remove the connecting cable - 2 - from the handle.

- Remove the connecting cable.

Installation

- Install in reverse order of removal.