Transmission Position Sensor/Switch: Adjustments

Multifunction Transmission Range Switch (F125), Adjusting

Special tools, testers and auxiliary items required

• Setting Gauge (T10173)

- Move the selector lever into the "N" position.

- Do not bend the selector lever cable.

Adjustment Prerequisites:

• The selector lever cable is disconnected from the selector shaft lever.

• The selector shaft is in the "N" position.

• The bolts for the multifunction transmission range switch have been loosened.

• The lever/selector shaft is removed.

Procedure

- Place the setting gauge (T10173) on the selector shaft - 2 - and turn the multifunction switch - 1 - until the setting gauge locks into the tab on the multifunction switch connector.






• If the tab on the connector does not lock into the groove in the setting gauge, then the transmission is no longer in "N". In this case, shift the transmission into the "N" position using the setting gauge.

- Tighten the setting gauge on the selector shaft - 2 - with the thumb screw - 3 -.

- Tighten the bolts - arrows - to 6 Nm.

- Remove the setting gauge.

- Further installation is performed in the reverse order. Refer to "Installing" in => [ Multifunction Transmission Range Switch (F125) ] Service and Repair.