Lock Cylinder

Lock Cylinder

Removing

• Only the driver door still has a lock cylinder.

• Removal and installation are described only for the left lock cylinder housing. The procedure for the right lock cylinder housing is derived accordingly from this.






• Cover cap for lock cylinder housing has been removed. Refer to => [ Door Handle ] Door Handle

- Remove the covers - 4 and 6 -.

- Remove the screw - 5 -.

- Pull out the door handle - 2 - until it stops and remove the bolt - 7 - until the lock cylinder housing - 1 - is able to be removed.

- Remove the lock cylinder housing - 1 - at a right angle - arrow - to the door from the door handle bracket - 3 -.

• Door handle remains standing in pulled-out position. Do not attempt to press door handle in, otherwise the retaining tab on the mounting bracket breaks off and a removed door handle can no longer be installed.

Installation






In pulled-out position - arrow -, door handle must stand off from door.

- Guide the lock cylinder housing - 3 - into the bracket at a right angle.

- Install the bolt - 3 - into the bracket.

Door handle - 1 - swings automatically on to door.

• The lock cylinder housing must be pressed onto the outer door panel while installing.

Install in reverse order of removal.

• Then, always perform a function test with door opened.