Access/Start System Antenna In Rear Bumper R136

Access/Start System Antenna In Rear Bumper R136

Component location of Access/start authorization antenna in rear bumper is behind the rear bumper cover.

• No coding, basic setting or adaptation is necessary if the Access/start authorization antenna in rear bumper is replaced. Erase the entry in the DTC memory via "guided fault finding" with the Vehicle Diagnostic Tester.

Removing

- Switch off the ignition and all electrical consumers and move the ignition key or start button into the 0 position (preliminary engaged position).

- Remove the rear bumper cover.

- Disengage Access/start authorization antenna in rear bumper - 1 - from lower section of bumper, paying attention to lengths of connected wires.






- Disengage and disconnect harness connector - 2 - and remove Access/start authorization antenna in rear bumper - 1 - from vehicle.

Installing

Install in reverse order of removal. Note the following:

- Connect harness connector - 2 - to the Access/start authorization antenna in rear bumper - 1 - until it engages.






- Insert Access/start authorization antenna in rear bumper - 1 - first into mount in bumper base and then press it into its end position until it engages.