Electrical Accessory Panel: Service and Repair

E-Box, Left Engine Compartment

Follow the procedure in the repair information when disconnecting and connecting the battery. Refer to => [ Battery, Disconnecting and Connecting ] Service and Repair.

Removing

- Disconnect the battery. Refer to => [ Battery, Disconnecting and Connecting ] Service and Repair.

- Slide securing bracket - 1 - in - direction of arrow - and remove cover of E-box - 2 - upward.






- Remove hex nuts - 1 -.






- Open the wiring guide covers on the E-box - 2 - in the - direction of the arrow -.

- Remove wires from connecting pins.

- Unclip wires from wire guides.

- Remove the central bolt - arrow - for the E-box - 1 -.






• Removing the central bolt - arrow - presses the E-box - 1 - up off the E-box bracket.

- Remove E-box - 1 - upward from E-box bracket.

- If necessary, remove air filter housing.

- Remove battery. Refer to => [ Battery, Removing and Installing ] Battery, Removing and Installing.

- Remove mounting bolts - arrows - for battery console - 1 -.






- Remove battery console - 1 - from vehicle.

- Press straps on E-box bracket apart from each other - arrows B - and slide flat terminal housing - 1 - sideways - arrow A - out of E-box bracket.






- Press straps on E-box bracket apart from each other - arrows C - and slide flat terminal housing - 2 - toward front - arrow D - out of E-box bracket.

- Remove the nuts - arrows - of E-box bracket - 1 -.






• It depends on vehicle equipment whether an auxiliary relay carrier is installed.

- Pull the E-box bracket - 1 - up off the stud bolts. Be careful of the connected wires.

- Unclip auxiliary relay carrier - 1 - sideways out of E-box bracket - 2 -.






- Remove E-box bracket - 2 - from vehicle.

Installing

Install in reverse order of removal. Note the following:

- Tighten the bolts and nuts to the tightening specifications.

Torque specifications: E-box, in engine compartment, left side











- Place cover - 2 - onto E-box and slide securing bracket - 1 - in - direction of arrow - until cover - 2 - is engaged.






• Then check whether cover - 2 - of E-box is correctly engaged.