Rear Lid Adjustment Buffer, Adjusting

Rear Lid Adjustment Buffer, Adjusting

• The following describes adjusting the right adjusting buffer. Adjusting the left adjusting buffer is identical.






- Loosen the clamping screw - 2 - until it is visible in the rubber buffer.

- Remove the notched slider - 1 - form the adjusting buffer.

- Set notched slider to dimension - a - = 12.5 mm.






- Close the rear lid in the initial locking position using light pressure over the center.

- Open the rear lid again.






- Install the clamping screw - 1 - for the adjustment buffer to a depth of - a - = 20 mm.

- Check the adjustment.