Front Door Window Basic Height Adjustment

Front Door Window Basic Height Adjustment

Special tools, testers and auxiliary items required

• Gauge (T10391)

• Socket (T10058)

• Side Window Installation Tool (V.A.G 1739)

• Socket wrench (T10471)

• Screw - 2 - can be adjusted by a total of 16 revolutions, screw - 5 - by 11 revolutions. The center position is the base setting.

• One turn = 1 mm adjustment.

• Right turn = door window up, left turn = door window down.

• New window regulators are delivered with the correct basic setting.






- Run the door window all the way down for the basic setting.

- Remove the caps - 4 - from the underside of the the door.

The hex ball socket (T10058) is suitable for turning the adjusting screw.

- Screw in the front adjusting screws - 5 - all the way down.

- Screw in the rear adjusting screws - 2 - all the way down.

- Screw the front adjusting screws - 5 - exactly 8 turns upward.

- Screw the rear adjusting screws - 2 - exactly 5 1/2 turns upward.

The center position is now reached. The basic adjustment is completed.