Suspension Control Module: Service and Repair

Electronic Damping Control Module

Removing

• Component location: Behind the left side luggage compartment trim panel.

- Switch off all electrical consumers.

- Remove the ignition key.

- Remove the left side trim in the luggage compartment.

- Disconnect the connector.

- Slightly bend the tabs on the bracket - arrows - upward and slide the electronic damping control module (J250) in - direction of arrow - out of the bracket.






Installing

Installation is the reverse of removal, with special attention to the following:

- Slide the electronic damping control module far enough into the bracket so that the tabs - arrows - audibly latch into place.






- Perform a basic setting on the adaptive chassis DCC. Refer to => [ Adaptive Chassis DCC, Basic Setting ] Testing and Inspection.