Rear Parking Aid Sensor (G203)/(G204)/(G205)/(G206)

Rear Parking Aid Sensor (G203)/(G204)/(G205)/(G206)

The following parking aid sensors are inside the rear bumper cover:

• Left rear parking aid sensor (G203)

• Left rear center parking aid sensor (G204)

• Right rear center parking aid sensor (G205)

• Right rear parking aid sensor (G206)

• All 4 rear parking aid sensors are removed the same way. Therefore, the procedure is only described for one sensor.

Removal

- Switch off the ignition and all electrical consumers and remove the ignition key.

- Remove the rear bumper cover.

Always follow the sequence for removing the sensor.

Otherwise, the sensor may be damaged. Hairline cracks which lead to sensor failure can develop if too much force is used on the sensor.

First take the sensors out of the brackets and then disconnect the sensor harness connector.

- Press the locking mechanisms - 2 - on the sensor bracket outward.






- Pull the sensor - 1 - backward out of the sensor bracket with the wires connected.

• When removing the sensor, make sure that the decoupling ring (black silicone ring) remains on the sensor head and does not remain in the bracket or get lost.

• Do not stretch the decoupling ring.

- Release and disconnect the harness connector - 2 - and remove the sensor - 1 -.






Installation

Installation is performed in the reverse order of removal. Note the following:

An incorrect or damaged coupling ring can lead to malfunctions.

Do not stretch the decoupling ring.

Replace damaged decoupling rings and ensure that the correct ring is installed.

- Check the sensor decoupling ring - 1 - for damage and replace if necessary.






• When installing the sensor, make sure the decoupling ring is correctly mounted on the sensor head and that it does not fall off or roll up when being inserted into the sensor bracket.

• Both tabs on the sensor mount must audibly engage when installing the sensor.

- Make sure the sensor is seated correctly in the bracket after installation. Dimension - a - for the circular gap between the sensor head and bumper cover must be even all around on the outer side of the bumper cover.